Hi I just got my self a Pinphone 3gs but it seems the firmware is an old one.
I835S_EU_CA_W_V1_0_3
Ive heard the newer firmware is much better so id like to update it.
Ive downloaded:
Firmware V1.1.3
Flashtool v3.0952
and the
MTK62xx comport-drivers
Ive linked the phone up using the standard usb to serial cord you get with the phone. Can I use this??? Or do I need to buy a different type???
When using the flashtool I try open the download agent
MTK_AlllnOne_DA.bin
And the scatter loader:
scat_MT6235_oxa.txt
The operation method is set to NFB
And the baudrate set to 115200 bps
however when I click download I get the following message preventing me from updating.
=============================================
FLASHTOOL ERROR: S_BROM_FAIL_TO_GET_BBCHIP_HW_VER (2022)
[H/W] fail to get target baseband chip H/W version!
possible reasons:
1. Theres an UART communication between FlashTool and BootROM.
2. Target might be shutdown unexpetedly.
[ACTION]
1. Try again.
2. Proceed H/W checking in download cable and target side UART path.
3. Monitor if power -drop occured in target side.
============================================
Can someone please tell me where Im going wrong or point me in the direction of a step by step tutorial. Ive searched all over the internet but the only luck Ive had is this forum.
Any help would be great thanks.
I835S_EU_CA_W_V1_0_3
Ive heard the newer firmware is much better so id like to update it.
Ive downloaded:
Firmware V1.1.3
Flashtool v3.0952
and the
MTK62xx comport-drivers
Ive linked the phone up using the standard usb to serial cord you get with the phone. Can I use this??? Or do I need to buy a different type???
When using the flashtool I try open the download agent
MTK_AlllnOne_DA.bin
And the scatter loader:
scat_MT6235_oxa.txt
The operation method is set to NFB
And the baudrate set to 115200 bps
however when I click download I get the following message preventing me from updating.
=============================================
FLASHTOOL ERROR: S_BROM_FAIL_TO_GET_BBCHIP_HW_VER (2022)
[H/W] fail to get target baseband chip H/W version!
possible reasons:
1. Theres an UART communication between FlashTool and BootROM.
2. Target might be shutdown unexpetedly.
[ACTION]
1. Try again.
2. Proceed H/W checking in download cable and target side UART path.
3. Monitor if power -drop occured in target side.
============================================
Can someone please tell me where Im going wrong or point me in the direction of a step by step tutorial. Ive searched all over the internet but the only luck Ive had is this forum.
Any help would be great thanks.
